In mold work, classification is not academic—it directly drives how you quote and design. Injection molds, blow molds, extrusion dies, die-casting dies, forging dies, and stamping dies each carry different steel selection, tolerance chains, and cycle requirements. A die-casting die for aluminum, for example, needs hot-work steel such as H13 and careful thermal fatigue control, while a stamping die may use SKD11 or Cr12MoV depending on batch size. If you misclassify the process at the quoting stage, you will likely underestimate machining hours, heat treatment, and trial-run costs. In practice, the first question is always: what material, what volume, what tolerance? Those three answers set the mold category and the cost baseline.
Cost breakdown is where many quotes go wrong. A typical mold quotation includes cavity and core steel, standard parts (mold base, ejector pins, springs, hot runner components), CNC and EDM hours, wire cutting, heat treatment, polishing, assembly, and trial shots. For a medium-complexity injection mold, steel and standard parts may account for roughly 30–40% of the tooling cost, while machining and finishing take the larger share. Do not forget design review, flow analysis, and correction loops after T1. Experienced engineers add a contingency for shrinkage adjustment, parting-line rework, and gate changes. A quote that ignores these items looks competitive but usually loses money during debugging.
From a shop-floor perspective, good quoting starts with a clear process sheet: cavity count, runner type, ejection layout, and steel hardness. For die-casting, add die temperature control and spray cooling; for stamping, add strip layout and die clearance. Keep historical data—actual machining hours, polishing time, and trial-shot rounds—because that is the only reliable basis for the next quote. If you need more mold sourcing and supplier information, visit MoldSo at www.moldso.com for practical references and mold sourcing support.
We just quoted a two-cavity PP cap tool and the steel choice alone swung the price about 30% — P20 for a 300k run versus hardened H13. What surprised me was how much the sliders and lifters added compared to the base cavity. When you quote, do you break out slider/lifter cost separately or just roll it into the total mold price? Trying to benchmark a few Chinese suppliers fairly.