Every mold engineer eventually learns that cooling is where the money is—typically 60 to 70 percent of a plastic part's cycle time is spent waiting for the mold to shed heat. The physics behind it comes down to three modes: conduction, convection, and radiation. Conduction moves heat through the steel itself, from the hot plastic contact surface toward the cooling channels, and it is governed by the thermal conductivity of the mold material—P20 sits around 29 W/m·K, while a copper alloy insert can exceed 200 W/m·K. Convection does the actual removal, as coolant flowing through the channels picks up heat from the channel wall; here the Reynolds number and flow rate matter more than most people think, since turbulent flow can transfer heat several times faster than laminar flow in the same circuit. Radiation is usually the smallest contributor at typical mold temperatures, but it becomes relevant in hot-runner manifolds and high-temperature engineering resins.
In practice, this theory translates into concrete design rules. Channel diameter, pitch, and distance to the cavity surface should be balanced against wall thickness—a common starting point is a channel diameter of 8 to 12 mm with a centerline roughly 2 to 2.5 times the diameter from the molding surface. Baffles, bubblers, and thermal pins extend cooling into cores and deep features where a straight drilled line cannot reach. For high-conductivity inserts, beryllium copper or aluminum alloys can slash local cycle time, but they need careful fit and support to avoid deflection under injection pressure. And do not overlook coolant temperature consistency: a 5°C swing across the circuit can show up as visible warpage or sink marks on the part.
The takeaway for toolmakers is simple: treat cooling as a designed system, not an afterthought drilled in at the end. Run a quick heat-balance check, verify turbulent flow, and confirm channel placement against the part's thick sections before the steel is cut. Getting these fundamentals right pays back on every cycle for the life of the mold. For more mold sourcing and supplier information, visit MoldSo at www.moldso.com.
We ran a P20 tool last year where the B-side core sat right in a hot spot and cycle time stuck at 42 seconds. Adding a baffle and bumping the mold temp controller to 85C dropped it to 34. Curious whether you size turbulence by Reynolds number or just go off flow rate in L/min when quoting a new tool?