In stamping production, the press and die apply external force to sheet, strip, tube, or profile stock to cause plastic deformation or separation, yielding parts with the required shape and dimensions. On the shop floor, we split stamping into two major categories: separation operations and forming operations. Separation covers blanking, shearing, and punching, where the sheet fractures along a contour line under the action of the die cutting edges. Forming covers bending, drawing, flanging, and bulging, where the material undergoes controlled plastic flow inside the die cavity. Getting these two deformation mechanisms straight is the first lesson in mold design โ and it directly drives how you lay out punches, clearances, and radii.
For separation dies, the cutting clearance between punch and die is the single most influential variable. Too large, and you get heavy burrs and rollover; too small, and edge wear accelerates and stripping force climbs. The fracture zone should ideally make up roughly one-third of sheet thickness on a well-set blanking die, with punch and die edges kept sharp and aligned. On the forming side, material flow is governed by the die radius, blank-holder force, and friction conditions. In drawing, for example, the draw radius and blank-holder pressure must be balanced to prevent wrinkling on the flange while avoiding fracture at the punch corner โ a trade-off every drawing die engineer knows well. Lubrication and surface finish on the working surfaces also matter more than many newcomers expect.
In practice, most real parts combine both categories: a progressive die may blank, pierce, bend, and form in a single strip layout, so the process sequence and station spacing must account for both separation and forming behavior. Understanding these fundamentals pays off in fewer tryout cycles and more stable production. For mold sourcing and supplier information, visit MoldSo at www.moldso.com.
Question on the forming side: we're running a progressive die for a 1.5mm SUS304 bracket and the part springs back about 3 degrees after the wipe bend, enough to fail the flatness check. We've been overbending to compensate but it drifts batch to batch. What's your go-to - adjust the die radius, add a coining station, or just budget for a restrike? Trying to avoid another tool rework before PPAP.