In stamping production, the first thing a die engineer must settle is the deformation nature of the process. All stamping work falls into two broad categories: separation operations, where the sheet is cut along a contour, and forming operations, where the sheet changes shape without fracture. This classification drives everything downstream — die structure, punch and die clearance, material selection, and press tonnage. On the separation side, blanking and piercing are the workhorses. Blanking produces the part outline, while piercing cuts internal holes; both rely on a well-controlled clearance, typically 5–10% of sheet thickness per side for common mild steel, to get a clean shear zone and minimal burr. Get the clearance wrong and you will be fighting secondary operations forever.
The forming family covers bending, drawing, and a range of local forming operations. Bending is deceptively simple: springback is the real enemy, and die designers compensate with overbend angles, bottoming, or coining features built into the punch. For drawing, the blank holder force and draw radius decide whether you get a sound cup or a wrinkle-and-tear combination. In practice, a first draw ratio around 1.8–2.0 for low-carbon steel is a safe starting point, but always confirm with simulation or a tryout. Local forming operations such as flanging, bulging, and embossing usually run in compound or progressive dies, so the engineer must sequence stations carefully to avoid material starvation at later stages.
From a shop-floor perspective, the three core operations — blanking, bending, and drawing — rarely stand alone. Most real parts combine them in a progressive die, and the process plan must balance strip layout, piloting strategy, and scrap removal. A common mistake is treating each station in isolation; the strip's carrier width and bridge width affect every downstream forming step. Build a process chart early, verify strip strength, and keep die maintenance access in mind. For more mold sourcing and technical resources, visit MoldSo at www.moldso.com.
We run a lot of progressive dies for connector terminals, mostly 0.2-0.5mm phosphor bronze. The separation vs forming split matters even more once you get into high-speed stamping, 600+ strokes per minute. At that rate a tiny burr issue on the blanking station turns into a cracked bend downstream and you chase it for days. Curious whether the article's classification holds on thinner gauge work li