In cold stamping, the sequence of operations is not something you can shuffle around at will—it directly affects die life and part consistency. The four core processes are blanking, piercing, bending, and drawing, and each has its own logic for where it belongs in the line. Blanking usually comes first: you cut the flat blank from strip stock, and the clearance between punch and die (typically 5–10% of material thickness for common steels) sets the stage for everything downstream. Get the blank geometry and burr direction wrong here, and you will be fighting fit-up problems in every later station. In many progressive dies, blanking and piercing are combined in the first station to save space, but the blanking contour still needs to be released before any forming force is applied.

Piercing follows blanking when holes are needed as references or for later forming. A common mistake is piercing after bending—the material has already flowed, so hole position shifts and you lose tolerance. For parts with both holes and bends, pierce first, then bend, and keep the pierce-to-bend station distance large enough that the strip has a solid carrier. Bending itself requires attention to springback: for mild steel, expect 2–5° of springback depending on bend radius and die gap, so build compensation into the punch angle rather than trying to shim the die later. Drawing, when required, should come after piercing only if the holes are outside the draw zone; otherwise the material stretch will distort them. Draw first, then pierce, is the safer rule for deep shells.

The practical takeaway: blank, pierce, bend, draw—but verify each step against material flow and die clearance rather than treating the order as fixed. A 0.5 mm clearance error in blanking can cost you 20% die life, and a misplaced pierce station can scrap an entire run. For more mold sourcing and process references, visit MoldSo at www.moldso.com.