In mold thermal management, heat moves through three mechanisms: conduction, convection, and radiation. Conduction dominates inside the mold steel—heat travels from the hot melt or casting through the core and cavity plates toward the cooling channels. The governing factor here is the thermal conductivity of the mold material: H13 tool steel sits around 25 W/m·K, while a copper alloy insert can exceed 380 W/m·K. That gap explains why beryllium copper or copper-core inserts are common in hot spots like cores and bosses, where standard steel simply cannot pull heat fast enough. Convection then takes over at the channel wall, where coolant flow rate and turbulence determine how much heat the water actually carries away—Reynolds numbers above roughly 10,000 are typically targeted to stay in the turbulent regime.
Radiation is often dismissed on the shop floor, but it matters in specific cases: open dies in die casting, hot runner manifolds, and large mold surfaces facing each other across an air gap. At typical mold temperatures the radiative share is small compared with conduction and convection, yet it becomes non-negligible when surface temperatures climb above 200–300°C or when air gaps interrupt the conduction path. In practice, engineers should prioritize channel layout and material selection first, then treat radiation as a secondary correction in thermal simulations rather than a design driver.
The practical takeaway is straightforward: match your cooling design to the dominant heat path. Use high-conductivity inserts where conduction is the bottleneck, verify turbulent flow in cooling lines, and account for radiation only where the geometry and temperature justify it. Getting these three mechanisms right pays off in shorter cycle times, reduced warpage, and longer tool life. For more mold sourcing and technical information, visit MoldSo at www.moldso.com.
Question on the convection side: we run a 4-cavity P20 mold with baffles in the cores, and we keep seeing a 15-20C delta between the two core circuits at the same flow rate. Pump is fine, hoses are matched. Would you look at turbulent flow first or check for scale buildup in the baffle channels? Trying to decide whether to pull the cores or just bump the flow.